SPRAY ADHESIVE HS 300 is a high strength adhesive - formulated without Methylene Chloride or other chlorinated solvents.
ADVANTAGES
- High strength formulation
- Longer open bond time - allows large areas to be covered before film dries
- Economical good coverage
- Free from chlorinated solvents
APPLICATIONS
Spray Adhesive HS 300 will provide high-strength bonds in many different areas:
- Chipboard and Concrete
- Insulation Materials
- Canvas and Leather
- Paper
- Wood and Cork
- Metal
- Plastic and Rubber
Apply an even coating to both surfaces to be bonded from 9 - 12 inches (25 - 30cm). Wait until the adhesive is tack-dry and bond the surfaces together using firm pressure.N.B. May affect certain plastics. Always test a small - inconspicuous area before general use. To prevent blockages - invert the can after use and spray to clear the nozzle.
SPECIFICATIONS
- Appearance : Clear - amber liquid.
- Odour : Acetone
- SG @ 25°C : 0.68
- Pressure @ 25°C : 3 Bar
- Discharge rate : 1.7 g/sec
- Polymer type : Styrene Isoprene Copolymer
- Tack time : Approximately 2-10 minutes
- Bonding time : Maximum adhesion in 12 - 24 hours
- Temperature range : Up to 50°C (dried film)
- Solubility : Soluble in some solvents - insoluble in water
- Flammability : Classified as extremely flammable under the EC Classification Labelling and Packaging regulation (CLP) 1272/2008
- Packaging : 500ml aerosol
STORAGE
The product may be stored at normal ambient temperatures and has a shelf life of not less than 36 months with correct storage. Aerosols should always be stored below 50°C - away from direct heat and naked flame.