SILICONE RELEASE FG is a multi-purpose - medium duty silicone mould release agent that is NSF M1 registered. It has been formulated as a highly effective - general purpose release agent for all thermoplastics and many types of moulded rubber used in the food processing industry.
NSF CLASSIFICATION STATEMENT:
This product is acceptable for use as a mould release agent (M1) on moulds that are used to produce packaging material that will contact food to prevent the finished product from adhering to the mould. The amount used on the equipment should be the minimum required to accomplish the effect.
APPLICATIONS
Provides a medium duty film for release of plastic and rubber parts in:
- Injection moulding
- Compression moulding
- Vacuum forming and many other Moulding and Forming processes
Will not build up in the mould and helps to improve surface finish - reduce rejects and increases production.Spray a light - even coating from 9 - 12 inches (25 - 30 cm) and re-apply as necessary
- NSF Registered : M1 (No. 149686)
- Appearance : Clear - colourless liquid
- Odour: Hydrocarbon
- Specifications/Approvals: NSF M1 149686
- SG @ 25C : 0.723
- Pressure @ 25C : 3.5 Bar
- Discharge rate : 0.8 g/sec
- Temperature range : Operational up to 200C
- Solubility : Soluble in solvents - insoluble in water
- Flammability : Classified as extremely flammable under current EC Regulations
- Flashpoint : Not applicable in sealed aerosol
- Packaging : 400 ml aerosol
STORAGE
The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.