FORMULA TWO is a specialist silicone mould release agent for the effective release of rubber. It is based on silicons and has been formulated particularly for quick and efficient release of natural rubber and polymers with lower melt temperatures.
APPLICATIONS
Provides a wet - silicone film for release of rubber moulded parts. Will not build up in the mould and helps to improve surface finish - reduce rejects and increase production.Particularly effective for use in the tyre industry and any other manufacturing processes involving rubber.N.B. Contains silicone so may be unsuitable where decorative work (e.g. painting - plating) is necessary on the moulded part. If a non-silicone product is required - use Formula Seven or Formula Four.Spray a light even coating from 9 - 12 inches (25 - 30 cm) and re-apply as necessary
- Appearance : Clear - colourless liquid
- Odour : Hydrocarbon solvent
- SG @ 25C : 0.81
- Pressure @ 25C : 3 Bar
- Discharge rate : 0.8 g/sec
- Temperature range : Operational up to 200C
- Solubility : Soluble in most solvents - insoluble in alcohols and water
- Flammability : Classified as extremely flammable under current EC Regulations
- Flashpoint : Not applicable in sealed aerosol
- Packaging : 500 ml aerosol
The product may be stored at normal ambient temperatures and has a shelf life of not less than 36 months with correct storage. Aerosols should always be stored below 50OC - away from direct heat and naked flame.