FORMULA ONE is a multi-purpose - heavy duty silicone mould release agent. It is based on a high percentage silicone formulation - designed for stubborn and hard to release plastic and rubber mouldings.
Applications
Provides a heavy duty film for release of difficult to release plastic and rubber parts in:
- Injection moulding
- Compression moulding
- Vacuum forming and many other moulding and forming processes
Will not build up in the mould and helps to improve surface finish - reduce rejects and increase productionAlso useful as an anti-stick agent in the:
- Textiles
- Foam converting
- Printing and shoe industries
N.B. Contains silicone so may be unsuitable where decorative work (e.g. painting - plating) is necessary on the moulded part. If a non-silicone product is required - use Formula Seven or Formula Four. Spray a light - even coating from 9 - 12 inches (25 - 30 cm) and re-apply as necessary.
- Appearance: Clear - colourless liquid
- Odour: Hydrocarbon
- SG @ 25C: 0.769
- Pressure @ 25C: 3.5 Bar
- Discharge rate: 0.85 g/sec
- Temperature range: Operational up to 200C (High temperature version also available - Formula One H.T operational up to 300°C)
- Solubility: Soluble in solvents - insoluble in water
- Flammability: Classified as extremely flammable under current EC Regulations
- Flashpoint: Not applicable in sealed aerosol
The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always be stored below 50°C - away from direct heat and naked flame.